Hello all,
I am in the process of assembling my MS3 Basic V3.0 board. I have successfully completed the clock circuit and its time to test it. I have loaded the latest firmware, opened tunerstudio and am streaming some information into it...Everything seems to be working flawlessly I feel really stupid for asking, but where the heck is this clock gauge in Tunerstudio the manual refers to? I have gone through every single menu and sub menu in Tuner studio and cannot figure out how to get the clock output from this circuit onto the gauge cluster. Any help would be appreciated and sorry for such a newb quesiton but its driving me nuts looking for this and I was finding nothing online anywhere.
clock gauge...Where are you?
Moderator: LT401Vette
-
- Site Admin
- Posts: 39617
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: clock gauge...Where are you?
Are you reading the correct manual? The crystal clock circuit is not used with MS3.
See the Manuals link above.
James
See the Manuals link above.
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: clock gauge...Where are you?
http://www.megamanual.com/ms2/V3assemble.htm
That is the manual I am using for assembly of the v3.0 board. There is no mention in it of ms3 not using that circuit. I will look at the ones on this site for reference going forward. I already installed the clock circuit and I am definately running ms3 basic so should I remove the components from the board or leave them?
That is the manual I am using for assembly of the v3.0 board. There is no mention in it of ms3 not using that circuit. I will look at the ones on this site for reference going forward. I already installed the clock circuit and I am definately running ms3 basic so should I remove the components from the board or leave them?
-
- Site Admin
- Posts: 39617
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: clock gauge...Where are you?
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".