Hi,
Can I please get some help about how to debug SD card logging issue - When TS connects to MS3 & I select the browse/import SD card files, all I got is a spinning circle that says "SD card card not in".
I created 2 indicators: sd_error & SD_Status on the dashboard, both showed 0.
This is the same SD card that used to work - I just downloaded the files off it from 2 years ago (unfortunately - the car had been down the last 2 years) so I assume the card is readable by MS3.
thanks!
SD Card Logging Help Please
Moderator: LT401Vette
-
- Site Admin
- Posts: 39615
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: SD Card Logging Help Please
That "SD status" means the card is not physically in.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: SD Card Logging Help Please
umm... the card is physically in and I can read it off my laptop.
Any suggestion of what to do next? Try another card?
Any suggestion of what to do next? Try another card?
Re: SD Card Logging Help Please
Are you putting the SD card in the ecu or just the laptop?
Cobra replica with 383 Chevy, ITB's, MS3X and LS2 coil near plugs
Re: SD Card Logging Help Please
The SD card is in the ECU (MS3 SD card slot). If I remove it & put into laptop, I can read the files. When I leave it in MS3, I got SD_status = SD_error = 0; which James said means MS3 doesn't see the card at all.cobratone wrote:Are you putting the SD card in the ecu or just the laptop?