Hi guys,
Looking for some advice, my tuner studio has worked perfectly up until now
But this message code comes up and I cannot find any info on it at all, can anyone shed some light
Error message help
Moderator: LT401Vette
-
- Super MS/Extra'er
- Posts: 12697
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Error message help
That is a pretty generic message. It essentially means there is a controller responding, but it is unable to read the calibration data back.
Can you post a Comm Debug Log?
- Close TunerStudio
- Delete the file TunerStudioAppDebug.txt
- Start TunerStudio
- on the main menu check "Communications --> Comm Debug Log"
- Open your project.
When you get the error, close TS again and post the TunerStudioAppDebug.txt
Can you post a Comm Debug Log?
- Close TunerStudio
- Delete the file TunerStudioAppDebug.txt
- Start TunerStudio
- on the main menu check "Communications --> Comm Debug Log"
- Open your project.
When you get the error, close TS again and post the TunerStudioAppDebug.txt
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html