no sensor cal drop down
Moderator: LT401Vette
no sensor cal drop down
The TunerStudio, tool tab is only providing a TPS cal selection....nothing for temp/thermistor, etc. Do you need to be connected to a live MS unit for this to be accessed and loaded.
-
- Site Admin
- Posts: 39619
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: no sensor cal drop down
Almost certainly yes.
Connect your Megasquirt ECU and create a new project.
James
Connect your Megasquirt ECU and create a new project.
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
- Super MS/Extra'er
- Posts: 1986
- Joined: Sat Jul 22, 2006 8:02 pm
- Location: Eureka, NV USA
- Contact:
Re: no sensor cal drop down
Did you try Unlock Calibrations?x-faktory wrote:The TunerStudio, tool tab is only providing a TPS cal selection....nothing for temp/thermistor, etc. Do you need to be connected to a live MS unit for this to be accessed and loaded.
Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
-
- Super MS/Extra'er
- Posts: 12733
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: no sensor cal drop down
It sounds like you have an MS1 project open.x-faktory wrote:The TunerStudio, tool tab is only providing a TPS cal selection....nothing for temp/thermistor, etc. Do you need to be connected to a live MS unit for this to be accessed and loaded.
If you do indeed had an MS1, there is no option to calibrate your thermoster or AFR tables.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html