Multiple CAN devices crashes Tunerstudio
Moderator: LT401Vette
-
- Super MS/Extra'er
- Posts: 12729
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Multiple CAN devices crashes Tunerstudio
Once TS can't get to 1 CAN device, it disables them all. It does not at this time support some missing CAN devices.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Re: Multiple CAN devices crashes Tunerstudio
It don't fully diable the can devices.
If i open a config dialog "menue" for the can device ts request the data.
It also request the data for the device which was not rechable during TS <-> MS connection start.
If i open a config dialog "menue" for the can device ts request the data.
It also request the data for the device which was not rechable during TS <-> MS connection start.
Alfa 156 GTA
Alfa 75 Race Car MS III -- alway latest FW
Alfa 164 V6 Turbo
Alfa 155 2,5TD RIP
Test MS II --always latest FW
Tunerstudio V2.6.11 Registered
MegaLog Viewer V3.4.04 Registered
Alfa 75 Race Car MS III -- alway latest FW
Alfa 164 V6 Turbo
Alfa 155 2,5TD RIP
Test MS II --always latest FW
Tunerstudio V2.6.11 Registered
MegaLog Viewer V3.4.04 Registered
Re: Multiple CAN devices crashes Tunerstudio
Obviously, you are the expert here, but I am pretty darn sure I have gotten data from 1 or 2 CAN devices in a project configured for 3, when only 1 or 2 are on the bus. I do disable the real-time data when there are missing devices. I remember that I would get individual messages for each of the missing devices saying something along the lines of disabling the missing device. The little red no smoking sign thing would show up on the stop light symbol in the lower right corner for the missing devices. The beta version was different, but I didn't take detailed notice of how it was different.LT401Vette wrote:Once TS can't get to 1 CAN device, it disables them all. It does not at this time support some missing CAN devices.