Can Loop variables drive indicators on dashboards?

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
jsiedlicki
Master MS/Extra'er
Posts: 687
Joined: Sun Jun 23, 2013 3:52 pm

Can Loop variables drive indicators on dashboards?

Post by jsiedlicki »

Can the new Loop variables from the Programmable On/Offs in MS3 be added to the list of possible output channels that drive the indicators? It would be nice for warning lights and the like when using a completely digital dash.
MS3-Pro 1st Gen | Honda K24 Supercharged
MS3/MS3X | SB Ford 347 stroker
Top
LT401Vette
Super MS/Extra'er
Posts: 12731
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:
Contact LT401Vette

Re: Can Loop variables drive indicators on dashboards?

Post by LT401Vette »

Check the Loop log field in the manual, or to access by OutputChannel the L is lower case loop.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Top
Post Reply

Return to “Tuner Studio”