Can Loop variables drive indicators on dashboards?
Moderator: LT401Vette
-
- Master MS/Extra'er
- Posts: 687
- Joined: Sun Jun 23, 2013 3:52 pm
Can Loop variables drive indicators on dashboards?
Can the new Loop variables from the Programmable On/Offs in MS3 be added to the list of possible output channels that drive the indicators? It would be nice for warning lights and the like when using a completely digital dash.
MS3-Pro 1st Gen | Honda K24 Supercharged
MS3/MS3X | SB Ford 347 stroker
MS3/MS3X | SB Ford 347 stroker
-
- Super MS/Extra'er
- Posts: 12733
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Can Loop variables drive indicators on dashboards?
Check the Loop log field in the manual, or to access by OutputChannel the L is lower case loop.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html