Am I being to ambitious in my thinking here?
Wondering if I hooked up the MS3 via CAN to a factory ECU in another car, can it sniff out and duplicate the map on that ECU?
Am I just plumb crazy? I'm thinking Plumb crazy.
MS3X CANbus Question
Moderator: LT401Vette
-
- Site Admin
- Posts: 39617
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: MS3X CANbus Question
Not going to happen!
To do what you are after you would need as a minimum a standalone CAN diagnostic tool, plus factory specifications or hundreds of hours for reverse engineering.
James
To do what you are after you would need as a minimum a standalone CAN diagnostic tool, plus factory specifications or hundreds of hours for reverse engineering.
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: MS3X CANbus Question
Oh darnjsmcortina wrote:Not going to happen!
To do what you are after you would need as a minimum a standalone CAN diagnostic tool, plus factory specifications or hundreds of hours for reverse engineering.
James
Thank for replying...