The EGOv1 gauge read .17 and did not vary. My AFR is still at 10.2 and i tested the voltage on the analog output from the wideband at the o2 input pin on the ecu harness and the wire is getting .17 with key off, and goes up to .73 while cranking. I would think that the gauge would also go up to the .73. Could there be any setting that would disrupt this circuit? The pin is clean and crimped nice on the wire, and is fully inserted into the harness, so i am sure the ECU is receiving the signal. The wideband signal ground is also spliced into my ecu signal ground pin.
on a side note, my computer restarted and must have updated something, because now when i try to open my project in TunerStudio, it says "Unexpected error occured loading project." but does not give me the prompt to view any error log. Then I click OK and it stays grayed out while the "loading tune" window is up, which it just freezes at. I can load any other project except the one ive got my tune saved on.