Page 1 of 1
crank position sensor
Posted: Thu Feb 09, 2017 11:24 am
by Cfritz2012
ยช-Jetski-Jet-Ski-Yamaha-66e-800cc-Flywheel.jpg
I am working on a project and i need some help figuring out how to set up the crank position sensor. its a 2 stroke 2 cylinder engine with a hall sensor type cps. what confuses me is that it has 2 teeth. one short one and right after it it has a long tooth the goes about 1/8 around the fly wheel. i would guess this is a twin trigger?
Re: crank position sensor
Posted: Thu Feb 09, 2017 11:55 am
by Matt Cramer
Currently, this pattern is not supported.
Re: crank position sensor
Posted: Thu Feb 09, 2017 12:52 pm
by Cfritz2012
Well that really puts a damper on my plans...
Re: crank position sensor
Posted: Thu Feb 09, 2017 1:01 pm
by Matt Cramer
Cfritz2012 wrote:Well that really puts a damper on my plans...
Well, you could take that damper and see if one of these fits...
https://www.diyautotune.com/support/tec ... k-trigger/
Re: crank position sensor
Posted: Thu Feb 09, 2017 1:22 pm
by Cfritz2012
I have a sensor and a wheel from yall. I just need to find out where to mount it. This specific engine doesn't have to many options for mounting.