Feature request: Tool to calculate lambda delay.

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Feature request: Tool to calculate lambda delay.

Postby piledriver » Sat May 06, 2017 1:53 am

It's been talked about as a test mode in the firmware, but it really belongs in Tunerstudio, as VEAL works AWESOME when the delay table is ~correct. A tool to do it automagically would cut tuning time dramatically in many cases.

Preferably user would just enable/disable for a short period as it would probably cause hiccups in normal running, and its not likely to change much unless the motor/exhaust/WBO2 changes drastically.

Plus, it would be a good baseline for the MS3 LTT lambda delay table.
(You could even stuff the results there, at least on MS3s)

Getting the data is probably a bit daunting for new users, even though its not really that hard to do.
(Its also not really documented that you might even need to do it, or how, anywhere)

The default values makes VEAL not work as awesome as it can on anything with long tube headers, at least...
When the delay table is sane, it works almost like magic.
Always doing things the hard way, MS2 sequential w/ v1.01 mainboard, LS2 coils. 80 mile/day commuter status.
piledriver
Super MS/Extra'er
 
Posts: 1625
Joined: Tue Oct 27, 2009 6:24 am
Location: Van Alstyne, Texas

Re: Feature request: Tool to calculate lambda delay.

Postby LT401Vette » Sun May 07, 2017 7:43 am

That has been on the todo list for years, I would think it should finally make it into the next major release.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
User avatar
LT401Vette
Super MS/Extra'er
 
Posts: 10181
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC


Return to Tuner Studio

Who is online

Users browsing this forum: No registered users and 3 guests