SD logging test on jimstim

General support questions and announcements for MS3. See also MS3 manuals.

Moderators: jsmcortina, muythaibxr

SD logging test on jimstim

Postby hulk8950 » Mon May 15, 2017 5:20 am

I am doing some testing on my ms3x with the Stims. I set up SD logging to be initiated with a push button, with the stimx i start the log with the "DL" dip switch, and switch it on then off as if it was a button. "Sampling" set to timed and "Log File Max Duration" set for a minimum of 1min. About a few minutes of watching and waiting for the SD Log light to turn off in TS, i noticed it would flash off then back on a couple times. I would have to physically power the Stims off to stop logging. When i withdraw the logs from the card i notice multiple 1 minute logs. Is there a way to actually stop logging thru the timing process without having to power down the Stims or vehicle once i get the squirt installed in the car? Any help would be appreciated, thanks chris
hulk8950
MS/Extra Newbie
 
Posts: 2
Joined: Thu Jun 11, 2015 11:44 am

Re: SD logging test on jimstim

Postby jsmcortina » Wed Jun 14, 2017 7:04 am

"Press the button" to stop it.
This is covered in the manual in section 3.8.4 of the Megasquirt-3 Setting Up Manual.

James
I can supply, repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: viewtopic.php?f=104&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
jsmcortina
Site Admin
 
Posts: 33830
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK

Re: SD logging test on jimstim

Postby hulk8950 » Wed Jun 14, 2017 11:04 am

James, i attempted switching the dip switch on and off several times trying to end logging, all this did was restart other Logs. Apparently it doesn't work properly with the Dip switches on the Stims and i just need to try it out in the car with an actual button.
Thanks chris
hulk8950
MS/Extra Newbie
 
Posts: 2
Joined: Thu Jun 11, 2015 11:44 am


Return to MS3 General Support

Who is online

Users browsing this forum: No registered users and 1 guest