How hook up Bluetooth rs232 adapter from efi analytic

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
bucksdmax
MS/Extra Newbie
Posts: 7
Joined: Fri May 27, 2016 5:13 pm

How hook up Bluetooth rs232 adapter from efi analytic

Post by bucksdmax »

I have the ms3 pro ecu with DIY's plug and play 24x harness. Bought Bluetooth adapter from efi analytics and have an android tablet with shadow dash loaded on it. Question is how do I hook up the adapter don't see anywhere where I can just plug it in or is something that needs wired in?
LT401Vette
Super MS/Extra'er
Posts: 12697
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:

Re: How hook up Bluetooth rs232 adapter from efi analytic

Post by LT401Vette »

Your MS3-Pro would have come with a DB9 cable that plugs into the harness. That also supplies power on Pin 9.
Plug that into your harness, then plug the BT Adapter into that.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
bucksdmax
MS/Extra Newbie
Posts: 7
Joined: Fri May 27, 2016 5:13 pm

Re: How hook up Bluetooth rs232 adapter from efi analytic

Post by bucksdmax »

Ok found the cable that plugs into the 4 prong serial plug but the db9 connector on the other end is female just like the rs232. Guessing I need to find a male adapter or pin my own db9 connector. Thanks for your help
Post Reply