SD Datalogging HP & Torque

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
anastos
MS/Extra Newbie
Posts: 19
Joined: Wed Aug 24, 2016 6:41 am

SD Datalogging HP & Torque

Post by anastos »

Hi All,
Running MS3 v1.5, TS 3.0.22. Not able to view HP or Torque in SD card data logs. I have Power & Torque in the selected data fields and have Log Power Fields set to log HP & TQ on the Performance & Economy Fields page. VSS is working well, some calculated fields working MPG etc. When I try to view HP or Torque in ML Viewer there is no selection available for those fields to load them in the graph. :(


Thanks,
Dave W.
LT401Vette
Super MS/Extra'er
Posts: 12697
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:

Re: SD Datalogging HP & Torque

Post by LT401Vette »

Is HP and torque in a normal data log?
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
anastos
MS/Extra Newbie
Posts: 19
Joined: Wed Aug 24, 2016 6:41 am

Re: SD Datalogging HP & Torque

Post by anastos »

I haven't tried to log it on my PC. I am using this MS3 in an SCCA race car ( Harsh environment for PC).
I did not initially notice the footnote for required inputs, apparently I need VSS1 & VSS2 I currently only have VSS1. I'm working on getting an ABS WSS connected to the car.
Post Reply