How to reset fuel used gauge

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
W126
Experienced MS/Extra'er
Posts: 153
Joined: Sun Aug 24, 2014 10:32 am

How to reset fuel used gauge

Post by W126 »

I tried to set "Single Click Action" in Designer Mode to "Clear Action" and "Reset Runtime Value",
neither works.
BTW. whats the difference between both ?
Brian H EFI
Helpful MS/Extra'er
Posts: 118
Joined: Tue Jul 09, 2013 1:01 pm

Re: How to reset fuel used gauge

Post by Brian H EFI »

I am assuming that you are using a gauge with metric units, if so then what you need to do is add an additional gauge that is the SAE equivalent then set it to use the "Reset Runtime Value" option. Now to reset the gauge you are actually using reset the SAE equivalent gauge and both should zero out for you.

"Clear Action" is used to clear the action that you had been previously set where "Reset Runtime Value" is the action you are assigning.
W126
Experienced MS/Extra'er
Posts: 153
Joined: Sun Aug 24, 2014 10:32 am

Re: How to reset fuel used gauge

Post by W126 »

strange, but works.
Thank you very much.
Post Reply