Curves, setting the dot free

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Curves, setting the dot free

Postby jsmcortina » Tue Aug 01, 2017 5:53 am

I know this has been discussed before, but I can't find how to implement it.
On some curves it would be useful to set the dot free, so it follows the X and Y axis instead of being stuck to a curve. Is this possible?
oilp.png
MS3 Oil Pressure
oilp.png (24.03 KiB) Viewed 166 times

Code: Select all
        curve = oil_curve, "Min/Max Oil Pressure vs. RPM"
            columnLabel = "RPM", "Min", "Max"
            xAxis       = 0, {rpmhigh}, 6
            yAxis       = 0, 300, 6
            xBins       = oil_rpm, rpm
            yBins       = oil_press_min
            yBins       = oil_press_max
          lineLabel   = "Min. pressure"
          lineLabel   = "Max. pressure"

James
I can supply, repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: viewtopic.php?f=104&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
jsmcortina
Site Admin
 
Posts: 33756
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK

Re: Curves, setting the dot free

Postby Brian H EFI » Wed Aug 02, 2017 9:01 am

Just add the coma and the output channel on the Y axis as you do with the x axis and the dot will follow both output channel variables rather then the X axis and the curve. With a little testing it would seem that when the Y axis has an output channel set it will allow the dot to be free above the highest value on the curve at the current X axis location but can not go below the curve so its not completely free. I will see if there is a way to make it completely free from the curve lines.
User avatar
Brian H EFI
Helpful MS/Extra'er
 
Posts: 99
Joined: Tue Jul 09, 2013 1:01 pm

Re: Curves, setting the dot free

Postby jsmcortina » Wed Aug 02, 2017 3:52 pm

You edited your post! I just tested and reached the same conclusion... the attached confirm what you are saying.
floatingdot-ok.png
Dot ok
floatingdot-ok.png (27.87 KiB) Viewed 108 times

floatingdot-nok.png
Dot not ok.
floatingdot-nok.png (28.74 KiB) Viewed 108 times

James
I can supply, repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: viewtopic.php?f=104&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
jsmcortina
Site Admin
 
Posts: 33756
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK


Return to Tuner Studio

Who is online

Users browsing this forum: No registered users and 4 guests