Need Config Error Added

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
Rick Finsta
Master MS/Extra'er
Posts: 548
Joined: Fri Dec 10, 2010 4:41 pm

Need Config Error Added

Post by Rick Finsta »

Phil/Brian-

Check out this thread:

http://www.msextra.com/forums/viewtopic ... 76#p508176

Running his tune on my MS3X and a Stim, I was getting the secondary stage on INJ2 instead of the 3X outputs (evidently the firmware won't allow this on anything more than a 4-cyl). I think there should be a configuration error popup in Tunerstudio for this situation, when you try to use the "Use MS3X (if possible)" option for a non-possible option. I got his setup working on the stim by running the primaries on the 3X outputs and the secondaries on INJ1/INJ2.

Let me know if you need additional information, but this was a frustrating one because the manual does say you can't do this with more than four cylinders, but the software lets you attempt it.
racingmini_mtl
Super MS/Extra'er
Posts: 9128
Joined: Sun May 02, 2004 6:51 am
Location: Quebec, Canada
Contact:

Re: Need Config Error Added

Post by racingmini_mtl »

The config errors are detected in the firmware not TunerStudio. You need to post that in the MS3 forum.
jbperf.com Main site . . . . . . . . . . . . . . . . . . . . . . jbperf.com Forum
Image
Rick Finsta
Master MS/Extra'er
Posts: 548
Joined: Fri Dec 10, 2010 4:41 pm

Re: Need Config Error Added

Post by Rick Finsta »

Thanks, will do!
Post Reply