Phil/Brian-
Check out this thread:
http://www.msextra.com/forums/viewtopic ... 76#p508176
Running his tune on my MS3X and a Stim, I was getting the secondary stage on INJ2 instead of the 3X outputs (evidently the firmware won't allow this on anything more than a 4-cyl). I think there should be a configuration error popup in Tunerstudio for this situation, when you try to use the "Use MS3X (if possible)" option for a non-possible option. I got his setup working on the stim by running the primaries on the 3X outputs and the secondaries on INJ1/INJ2.
Let me know if you need additional information, but this was a frustrating one because the manual does say you can't do this with more than four cylinders, but the software lets you attempt it.
Need Config Error Added
Moderator: LT401Vette
-
- Master MS/Extra'er
- Posts: 548
- Joined: Fri Dec 10, 2010 4:41 pm
-
- Super MS/Extra'er
- Posts: 9130
- Joined: Sun May 02, 2004 6:51 am
- Location: Quebec, Canada
- Contact:
Re: Need Config Error Added
The config errors are detected in the firmware not TunerStudio. You need to post that in the MS3 forum.
-
- Master MS/Extra'er
- Posts: 548
- Joined: Fri Dec 10, 2010 4:41 pm
Re: Need Config Error Added
Thanks, will do!