Need Config Error Added
Posted: Wed Aug 02, 2017 4:28 pm
Phil/Brian-
Check out this thread:
http://www.msextra.com/forums/viewtopic ... 76#p508176
Running his tune on my MS3X and a Stim, I was getting the secondary stage on INJ2 instead of the 3X outputs (evidently the firmware won't allow this on anything more than a 4-cyl). I think there should be a configuration error popup in Tunerstudio for this situation, when you try to use the "Use MS3X (if possible)" option for a non-possible option. I got his setup working on the stim by running the primaries on the 3X outputs and the secondaries on INJ1/INJ2.
Let me know if you need additional information, but this was a frustrating one because the manual does say you can't do this with more than four cylinders, but the software lets you attempt it.
Check out this thread:
http://www.msextra.com/forums/viewtopic ... 76#p508176
Running his tune on my MS3X and a Stim, I was getting the secondary stage on INJ2 instead of the 3X outputs (evidently the firmware won't allow this on anything more than a 4-cyl). I think there should be a configuration error popup in Tunerstudio for this situation, when you try to use the "Use MS3X (if possible)" option for a non-possible option. I got his setup working on the stim by running the primaries on the 3X outputs and the secondaries on INJ1/INJ2.
Let me know if you need additional information, but this was a frustrating one because the manual does say you can't do this with more than four cylinders, but the software lets you attempt it.