FR: show filename of loaded file in table-windows

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
BigBlockMopar
Experienced MS/Extra'er
Posts: 372
Joined: Sat Dec 31, 2011 6:10 am
Location: Netherlands
Contact:

FR: show filename of loaded file in table-windows

Post by BigBlockMopar »

Would it possible to show the name of the .table-file that (if so) has been loaded in the ignition table-window?
Also, provided no cells have been changed since the previously saved table-file was loaded.
When even one cell is changed, the filename should disappear from the window (or maybe "-altered" or "-Modified" could be added) as it's not valid anymore, that is, until the table is saved again and its filename should reappear again in the window.

Reasoning:
Working with 2 tables (IGN table1 and IGN table3), I sometimes get confused which table is currently in use, and have then to take screenshots of TS ignition tables to compare with earlier saved tables on file.

For instance;
Image
Daily driver: 1973 Dodge Dart - 360ci engine - 11.3:1cr - MS3x - ignition only. 42RH/A500 OD+LU transmission / 3.23 gears
--------------
Website: https://www.bigblockmopar.nl/
YouTube Channel: https://www.youtube.com/c/BigBlockMopar
LT401Vette
Super MS/Extra'er
Posts: 12697
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:

Re: FR: show filename of loaded file in table-windows

Post by LT401Vette »

Anything is possible...
It is an interesting idea.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Post Reply