Quick Custom Channel Question
Moderator: LT401Vette
Quick Custom Channel Question
I've setup my Microsquirt as an I/O box and built the circuit referenced in this thread http://www.msextra.com/forums/viewtopic ... fuel+level. I am now trying to set up a fuel level gauge in TS, but I am not sure what to input for Units. I do not know what to choose for empty or full? Or should it be volts or ohms?
1995 Ford Lightning. Dart based 427 Windsor, Novi 2000, full sequential, E-85, etc. MS3X/v3.57
http://www.buildpics.org/
http://www.buildpics.org/
-
- Super MS/Extra'er
- Posts: 12733
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Quick Custom Channel Question
I have seen some cars put /1 as a unit.
But, Units is optional. You don't need to put anything.
But, Units is optional. You don't need to put anything.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html