Quick Custom Channel Question

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
Raymond_B
Super MS/Extra'er
Posts: 1394
Joined: Thu Mar 06, 2014 2:17 pm
Location: Texas
Contact:

Quick Custom Channel Question

Post by Raymond_B »

I've setup my Microsquirt as an I/O box and built the circuit referenced in this thread http://www.msextra.com/forums/viewtopic ... fuel+level. I am now trying to set up a fuel level gauge in TS, but I am not sure what to input for Units. I do not know what to choose for empty or full? Or should it be volts or ohms?
1995 Ford Lightning. Dart based 427 Windsor, Novi 2000, full sequential, E-85, etc. MS3X/v3.57
http://www.buildpics.org/
LT401Vette
Super MS/Extra'er
Posts: 12697
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:

Re: Quick Custom Channel Question

Post by LT401Vette »

I have seen some cars put /1 as a unit.
But, Units is optional. You don't need to put anything.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Post Reply