Calibrating Oil Pressure Sensor
Posted: Mon Nov 20, 2017 12:16 pm
I have 3 AEM sensors, 2 0-100 psi sensors and 1 0-50 psi sensor so I imagine answering this question will help me with all 3.
I think it's just me being dense, but I have not been able to get my oil pressure gauge to match what my mechanical reads, it is using the 0-100 psi sensor. I set up ADC13 in generic sensors to use raw data then created a custom channel and input the .5v and 4.5v values from the chart below. However it seems to be consistently 10 psi off. I did not set it up as linear as I do not know what the values would be for 0 and 5 volts. Clearly I am missing something.
I think it's just me being dense, but I have not been able to get my oil pressure gauge to match what my mechanical reads, it is using the 0-100 psi sensor. I set up ADC13 in generic sensors to use raw data then created a custom channel and input the .5v and 4.5v values from the chart below. However it seems to be consistently 10 psi off. I did not set it up as linear as I do not know what the values would be for 0 and 5 volts. Clearly I am missing something.