A bug... I think?
Posted: Tue Dec 26, 2017 5:18 pm
While trying to adjust ASE on my car I just experienced something that I thought was a tuning limit, but it appears to me to be a bug in TS?
Here's how I can reproduce it on my machine:
* First make sure in the ASE (not ASE taper, just ASE) dialog, that the option to "Auto scale Y axis maximum" is off.
* Open the attached .msq - at least for me I get the same result if I open a predefined or temporary project.
* Open the dialog to edit ASE. It should come up looking like this: * In the graph window, click to edit the leftmost visible point (the blue dot just below the 100% Y-axis line).
* Use the up or down arrow to change the value. The graph should rescale so it looks like this: * In the graph window, click the leftmost blue dot to edit it.
* Try to increase the value. When I do that, it won't allow me to increase the value above 140.
I thought this was because the ASE values were somehow limited to 140. But when I go into the table and manually edit the numbers (or use Q/W to increase/decrease), I can go all the way up to 400!
If I turn on the "Auto scale Y axis maximum" option, the behavior is somewhat different. As I try to increase the value, up to a point the Y axis will rescale and allow me to continue increasing the value... up to a point. Eventually it will rescale with the Y max somewhere in the low 300s and won't allow me (by using up/down in the graph) to increase the value further.
Oh and this is TS version 3.0.50.23 running on Windows 10 x64. The problem doesn't seem dependent on firmware version... I tried a bunch of (MS3) .msq files I had going back years and the problem occurs with all of them.
Here's how I can reproduce it on my machine:
* First make sure in the ASE (not ASE taper, just ASE) dialog, that the option to "Auto scale Y axis maximum" is off.
* Open the attached .msq - at least for me I get the same result if I open a predefined or temporary project.
* Open the dialog to edit ASE. It should come up looking like this: * In the graph window, click to edit the leftmost visible point (the blue dot just below the 100% Y-axis line).
* Use the up or down arrow to change the value. The graph should rescale so it looks like this: * In the graph window, click the leftmost blue dot to edit it.
* Try to increase the value. When I do that, it won't allow me to increase the value above 140.
I thought this was because the ASE values were somehow limited to 140. But when I go into the table and manually edit the numbers (or use Q/W to increase/decrease), I can go all the way up to 400!
If I turn on the "Auto scale Y axis maximum" option, the behavior is somewhat different. As I try to increase the value, up to a point the Y axis will rescale and allow me to continue increasing the value... up to a point. Eventually it will rescale with the Y max somewhere in the low 300s and won't allow me (by using up/down in the graph) to increase the value further.
Oh and this is TS version 3.0.50.23 running on Windows 10 x64. The problem doesn't seem dependent on firmware version... I tried a bunch of (MS3) .msq files I had going back years and the problem occurs with all of them.