The RPM REV limiter did not work(

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
Valeriy
Helpful MS/Extra'er
Posts: 78
Joined: Sat Oct 21, 2017 11:54 am
Contact:

The RPM REV limiter did not work(

Post by Valeriy »

Today I decided to write down the log file and there was a disaster! After I pressed the throttle on a neutral gear, my engine spun up instantly to 8025rpm, although the limiter was at 6000rpm. With such high revs my engine could not stand it and broke the pin of the gear on the crankshaft which goes to the gas distribution mechanism. Now I need to remove the heads of the block and change all 24 pieces of intake and exhaust valves at best. What I set up is not correct? What caused such a big engine speed? :(
мин.msq
My msd
(282.86 KiB) Downloaded 102 times
Attachments
Срезало шпонку коленвала 2.jpg
Срезало шпонку коленвала 2.jpg (318.56 KiB) Viewed 733 times
Срезало шпонку коленвала.jpg
Срезало шпонку коленвала.jpg (224.94 KiB) Viewed 733 times
Reverant
Super MS/Extra'er
Posts: 1233
Joined: Sat Apr 15, 2006 12:39 am
Location: Athens, Greece

Re: The RPM REV limiter did not work(

Post by Reverant »

This is an MS3 generic support issue, not a TunerStudio issue.

Is either of "Fuel Cut" or "Spark Cut" enabled in the first picture?
The man behind MS Labs
2005 Audi A3 2.0L TFSI DSG AWD - Extreme MS3
2002 Mazda Miata 1.8 6sp - Enhanced MS3 1.4.0, sequential injection, sequential ignition, big turbo, lots of boost
2swe
Experienced MS/Extra'er
Posts: 330
Joined: Sun Dec 25, 2011 12:41 pm

Re: The RPM REV limiter did not work(

Post by 2swe »

"Fuel Cut" or "Spark Cut" not enabled..
"spark retard" alone can not prevent the engine from overspeed.
1978 vw golf gti 16v itb cop full sequential MS2
1992 vw corrado 16v moonlight blue MS2
Valeriy
Helpful MS/Extra'er
Posts: 78
Joined: Sat Oct 21, 2017 11:54 am
Contact:

Re: The RPM REV limiter did not work(

Post by Valeriy »

Reverant wrote:This is an MS3 generic support issue, not a TunerStudio issue.

Is either of "Fuel Cut" or "Spark Cut" enabled in the first picture?
Thank you for attention! It's my stupidity I missed these points cutting off the spark and fuel (I usually use a spark cut but this time I missed this which caused the engine to crash :( Now I'll go see the consequences, remove the heads of the block!
Last edited by Valeriy on Sat Dec 30, 2017 9:27 pm, edited 1 time in total.
Post Reply