Sequential Basic Setup

[kinguin]

I'm very new to this forum (first post). I've searched around for how to setup for a sequential system. All the manuals I've read say to set the mode to sequential in the basic/load settings menu or in the advanced menu. Neither of these buttons exist in my build of TunerStudio MS v3.0.28. Perhaps it is very obvious and I am just missing the button. I've used the search feature here and have not found this topic brought up. The manual I am looking through was not written for the latest software, and I am unable to make any progress.

I appreciate any help,

Randall

[LT401Vette]

What menus and dialogs you have completely depend on what firmware you are running.
Are you looking at the right manual for your firmware?