I'm very new to this forum (first post). I've searched around for how to setup for a sequential system. All the manuals I've read say to set the mode to sequential in the basic/load settings menu or in the advanced menu. Neither of these buttons exist in my build of TunerStudio MS v3.0.28. Perhaps it is very obvious and I am just missing the button. I've used the search feature here and have not found this topic brought up. The manual I am looking through was not written for the latest software, and I am unable to make any progress.
I appreciate any help,
Randall
Sequential Basic Setup
Moderator: LT401Vette
-
- Super MS/Extra'er
- Posts: 12729
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Sequential Basic Setup
What menus and dialogs you have completely depend on what firmware you are running.
Are you looking at the right manual for your firmware?
Are you looking at the right manual for your firmware?
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html