Hi,
a very nice feature when capturing a datalog, would be to save the .msq alongside with the datalog, with the same name as the datalog but with the .msq extension.
So let's say the user starts a datalog named "2014-09-07_13.23.50.msl". TunerStudio will also create a file named "2014-09-07_13.23.50.msq" in the same folder, so that the matching map that resulted in this log is available.
MegaLogViewer will also look for the matching .msq when opening a datalog, so that the "current" tables are always shown in the tuning console.
Thoughts?
Save .msq at the same time with the datalog.
Moderator: LT401Vette
Save .msq at the same time with the datalog.
The man behind MS Labs
2005 Audi A3 2.0L TFSI DSG AWD - Extreme MS3
2002 Mazda Miata 1.8 6sp - Enhanced MS3 1.4.0, sequential injection, sequential ignition, big turbo, lots of boost
2005 Audi A3 2.0L TFSI DSG AWD - Extreme MS3
2002 Mazda Miata 1.8 6sp - Enhanced MS3 1.4.0, sequential injection, sequential ignition, big turbo, lots of boost
-
- Super MS/Extra'er
- Posts: 12731
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Save .msq at the same time with the datalog.
I have thought about that... To embed the msq info into a data log would be nice.
The one point of confusion I see is if the tune was changed during the log.
Should the cal data be from the start of the log or end. Perhaps embed 2 msq snapshots and let the user decide which to use.
The one point of confusion I see is if the tune was changed during the log.
Should the cal data be from the start of the log or end. Perhaps embed 2 msq snapshots and let the user decide which to use.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Re: Save .msq at the same time with the datalog.
I think just the start would be sufficient.
The man behind MS Labs
2005 Audi A3 2.0L TFSI DSG AWD - Extreme MS3
2002 Mazda Miata 1.8 6sp - Enhanced MS3 1.4.0, sequential injection, sequential ignition, big turbo, lots of boost
2005 Audi A3 2.0L TFSI DSG AWD - Extreme MS3
2002 Mazda Miata 1.8 6sp - Enhanced MS3 1.4.0, sequential injection, sequential ignition, big turbo, lots of boost
-
- Experienced MS/Extra'er
- Posts: 354
- Joined: Tue Mar 22, 2016 2:26 pm
Re: Save .msq at the same time with the datalog.
I've had this happen to me several times as well. I do remote tuning, and have had the Customer send me a Datalog of the wrong tune. Wastes a lot of time.