Unless you actually removed the surface mount resistor from the board, your MS3 should have the terminating 120 Ohm resistor.NArcher wrote:Sorry, another CAN question.
I have an ABS computer that I would like to receive the data from and pass to the vss to get speedo to work. Which part of the code do I have to modify to make this work. I am [also] a poor programmer but am continuously learning!
As for your second request, there is no support for receiving data from a device that is not using the MS CAN protocol (nor are there plans for it at this time as far as I know). So you would need to program that in and it's not a beginner project. And even then that assumes you actually know what the protocol and data format from the ABS computer are. If not then it is even more advanced and needs reverse engineering the CAN protocol.
Jean