I'm not sure if this is a MS3 question or a TS / MLV question. Feel free to move if needed.
I'm currently tuning using MAF and want to log and display the MAF signal as either volts or A/D counts along with the current MAF reading in g/s. I'm using the SpareADC channel on the MS3X board for the MAF sensor. I have attempted to configure the same SpareADC as a spare input (raw ADC count) to get it to show up in the log and I get a configuration error complaining about the same input being used twice.
Is there a way to specify an already used input to be logged using a different interpretation? What I want is to generate data for MAF and MAFVolts off of the same A/D channel.
1977 BMW 320i with Variable length intake, MAF, COP, IAC, Sequential fuel and spark, MS3 knock sensing
MS3 / MS3X / V3 mainboard, MS3 V1.4 beta 14
Tuner Studio 2.6.01