Configure 2 different interpretations of same input?
Posted: Wed Mar 14, 2012 6:20 am
I'm not sure if this is a MS3 question or a TS / MLV question. Feel free to move if needed.
I'm currently tuning using MAF and want to log and display the MAF signal as either volts or A/D counts along with the current MAF reading in g/s. I'm using the SpareADC channel on the MS3X board for the MAF sensor. I have attempted to configure the same SpareADC as a spare input (raw ADC count) to get it to show up in the log and I get a configuration error complaining about the same input being used twice.
Is there a way to specify an already used input to be logged using a different interpretation? What I want is to generate data for MAF and MAFVolts off of the same A/D channel.
I'm currently tuning using MAF and want to log and display the MAF signal as either volts or A/D counts along with the current MAF reading in g/s. I'm using the SpareADC channel on the MS3X board for the MAF sensor. I have attempted to configure the same SpareADC as a spare input (raw ADC count) to get it to show up in the log and I get a configuration error complaining about the same input being used twice.
Is there a way to specify an already used input to be logged using a different interpretation? What I want is to generate data for MAF and MAFVolts off of the same A/D channel.