Configure 2 different interpretations of same input?

Testing and development of Megasquirt 3

Moderators: jsmcortina, muythaibxr

Post Reply
shauer
Experienced MS/Extra'er
Posts: 364
Joined: Wed Oct 05, 2005 10:39 am
Location: Rochester, NY USA
Contact:

Configure 2 different interpretations of same input?

Post by shauer »

I'm not sure if this is a MS3 question or a TS / MLV question. Feel free to move if needed.

I'm currently tuning using MAF and want to log and display the MAF signal as either volts or A/D counts along with the current MAF reading in g/s. I'm using the SpareADC channel on the MS3X board for the MAF sensor. I have attempted to configure the same SpareADC as a spare input (raw ADC count) to get it to show up in the log and I get a configuration error complaining about the same input being used twice.

Is there a way to specify an already used input to be logged using a different interpretation? What I want is to generate data for MAF and MAFVolts off of the same A/D channel.
Steve Hauer
http://www.77e21.info
1977 BMW 320i with MAF, COP, IAC, Sequential fuel and spark, MS3 knock sensing
MS3 / MS3X / V3 mainboard, MS3 V1.5 a4
jsmcortina
Site Admin
Posts: 39585
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK
Contact:

Re: Configure 2 different interpretations of same input?

Post by jsmcortina »

Use the generic sensors and "allow input sharing".

James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
shauer
Experienced MS/Extra'er
Posts: 364
Joined: Wed Oct 05, 2005 10:39 am
Location: Rochester, NY USA
Contact:

Re: Configure 2 different interpretations of same input?

Post by shauer »

Now don't I feel foolish for not noticing that! :oops:

Thanks James.
Steve Hauer
http://www.77e21.info
1977 BMW 320i with MAF, COP, IAC, Sequential fuel and spark, MS3 knock sensing
MS3 / MS3X / V3 mainboard, MS3 V1.5 a4
elaw
Super MS/Extra'er
Posts: 2926
Joined: Fri Oct 16, 2009 6:20 am
Location: Wilmington, MA

Re: Configure 2 different interpretations of same input?

Post by elaw »

shauer wrote:Now don't I feel foolish for not noticing that! :oops:
That makes two of us! :lol:
Eric Law
1990 Audi 80 quattro with AAN turbo engine: happily running on MS3+MS3X
2012 Audi A4 quattro, desperately in need of tweaking

Be alert! America needs more lerts.
Post Reply