MS3 pre1.1 release candidate 1
Moderators: jsmcortina, muythaibxr
Re: MS3 pre1.1 release candidate 1
Thanks, I had a feeling that's what needed to be done I just wasn't positive.
Linfert Performance/321 Motorsports
SCCA 2019 SM National Champion Crew Chief
SCCA 2023 FP National Champion Tuner/electrical engineer
100s of MS systems built installed and tuned
Support the developers!
SCCA 2019 SM National Champion Crew Chief
SCCA 2023 FP National Champion Tuner/electrical engineer
100s of MS systems built installed and tuned
Support the developers!
Re: MS3 pre1.1 release candidate 1
4. Run TunerStudio.jsmcortina wrote:In what way?shortbus wrote:The README.txt needs updating.
James
TunerStudio v1.21 or later is required.
Should be:
4. Run TunerStudio.
TunerStudio v2.0.x or later is required.
-
- Site Admin
- Posts: 39621
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: MS3 pre1.1 release candidate 1
What features were added post 1.21 that are required?
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: MS3 pre1.1 release candidate 1
I don't know. I was just going by the first post of this thread that said "EDIT: Reminder, you must use the beta or 2.0+ versions of TunerStudio. 1.00x WILL NOT WORK."
Not trying to be difficult. Just trying to help it all be consistent. Sorry if my efforts are unwanted.
Not trying to be difficult. Just trying to help it all be consistent. Sorry if my efforts are unwanted.
Re: MS3 pre1.1 release candidate 1
will this code have the toyota vvti.wheel pattern 36 2 and 3 tooth on the camshaft?
-
- Site Admin
- Posts: 39621
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: MS3 pre1.1 release candidate 1
Please start a new topic with full details for that wheel arrangement.joooeone wrote:will this code have the toyota vvti.wheel pattern 36 2 and 3 tooth on the camshaft?
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".