Hello,
I just started with Megasquirt in the past week. I have an MS3-Pro and I would like to be able to build from source and run what I have built. I have been able to get v1.4.0 source and the build tools installed and have been able to get the code built to an 'ms3pro.s19' file. The binary is downloaded successfully to the MS3 but running TunerStudio (v2.6.19) gives me the "Wrong Code Loaded" error. The description string and the 'format' code from the MS3 comes up correctly in TunerStudio but the error is present anyway.
I should mention that I can load the 'release' version of v1.4.0 and it runs correctly. But I have these problems when I build from source.
Can anyone please help me to determine what I am doing wrong?
Thanks,
Matt
"Wrong Code Loaded" Error - Building from Source
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39615
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: "Wrong Code Loaded" Error - Building from Source
Be sure to
James
Code: Select all
make clean
make ms3pro
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: "Wrong Code Loaded" Error - Building from Source
OK, thanks! I will give that a shot later today.
Matt
Matt