MS3 pre-1.4.2 beta 3 released

Testing and development of Megasquirt 3

Moderators: jsmcortina, muythaibxr

Post Reply
jsmcortina
Site Admin
Posts: 39587
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK
Contact:

MS3 pre-1.4.2 beta 3 released

Post by jsmcortina »

To announce the release of "MS3 Pre 1.4.2 beta 3"
Who should use this code?
Users requiring the bug-fixes.

Who should not use this code?
New or casual users – please use the current release code instead – see the Downloads page linked above.

Main changes since the pre-1.4.2 beta 2 firmware
Bug fixes:
Only check config errors at boot to reduce chance of lockup when loading a defective MSQ.
SDcard FAT32 erase tweak.
Lambda target now respects stoich value. (Ancient issue.)

New / changed features:
-

Minor / internal:
-

The firmware zip is available from:

http://www.msextra.com/downloads/dev/ms3/1-4-2/beta-3/

Be sure to read the README.txt and RELEASE-NOTES.txt that are supplied in the zipfile.

Upgrading users are advised to enable the "old baro calc" for backwards compatability.

Some of the ini changes will result in harmless warnings when loading MSQs from 1.4.x
Users upgrading from 1.2.x or earlier codes need to pay more attention.
TunerStudio 2.6.x or later is REQUIRED.

Go ahead and use the built-in firmware loader on the Tools menu of TunerStudio 3.0.x - you'll like it.
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Post Reply