The fuel density correction table exists and seems active, but the manual says (and TS grays out the boxes) it's not active unless dual fuel is selected.
It seems the ~%6 reduction from -40F to 120F (for either gasoline or ethanol) would be still a thing even if not running dual fuel.
Also, the inputs are listed as sensor1, sensor2 etc, which one is the flex input?
Or is the table active because I have the flex temp sensor input active?
Running ms3-pre1.5b2
Fuel density correction using ethanol sensor?
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 1681
- Joined: Tue Oct 27, 2009 6:24 am
- Location: Van Alstyne, Texas
Fuel density correction using ethanol sensor?
Always doing things the hard way, MS2 sequential w/ v1.01 mainboard, LS2 coils. 80 mile/day commuter status.
-
- Site Admin
- Posts: 39612
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Fuel density correction using ethanol sensor?
I tested and I'm able to get the curve ungreyed.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".