Hi guys,
I have question:
To high rpm, if I press tps and the turbocharger spoll, in many cases I have knock. If I press TPS at low rpm and I run to high rpm I dont have knock.
The knock is during spool for a few time.
I did not properly analyze the logs during this problem, but I think is possible use RPMdot for detect the spool. In this case, my idea is a curve for decrease advance during spool.
You think is good idea?
Regards
Cristian
MAPdot, advance and Knock
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 855
- Joined: Sun Oct 10, 2010 6:33 am
-
- Super MS/Extra'er
- Posts: 2221
- Joined: Tue May 04, 2004 8:20 pm
- Location: St Louis
- Contact:
-
- Super MS/Extra'er
- Posts: 2221
- Joined: Tue May 04, 2004 8:20 pm
- Location: St Louis
- Contact:
Re: MAPdot, advance and Knock
By the way, this sort of issue is where having the registered version of MLV or even better, MLV HD. Also having knock detection is a huge advantage.
Andy
Andy
-
- Super MS/Extra'er
- Posts: 855
- Joined: Sun Oct 10, 2010 6:33 am
Re: MAPdot, advance and Knock
I have all license. When i tuned the engine I have always headphone. I m sure when the engine have knock. During spool is critical condiction.
-
- Super MS/Extra'er
- Posts: 2221
- Joined: Tue May 04, 2004 8:20 pm
- Location: St Louis
- Contact:
Re: MAPdot, advance and Knock
Here is what a knock trace looks like. This happens to be a different system but similar.
http://www.nbs-stl.com/HarleyTuning/Harley_Knock.png
In a histogram view, it looks like this.
http://www.nbs-stl.com/HarleyTuning/98f ... togram.png
my point is, you need to know exactly where the knock is happening an where the motor came from right before the knock started was noticeable. Histogram view makes that very easy. Histogram view comes with MLV HD.
Andy
http://www.nbs-stl.com/HarleyTuning/Harley_Knock.png
In a histogram view, it looks like this.
http://www.nbs-stl.com/HarleyTuning/98f ... togram.png
my point is, you need to know exactly where the knock is happening an where the motor came from right before the knock started was noticeable. Histogram view makes that very easy. Histogram view comes with MLV HD.
Andy
-
- Super MS/Extra'er
- Posts: 2221
- Joined: Tue May 04, 2004 8:20 pm
- Location: St Louis
- Contact:
Re: MAPdot, advance and Knock
Here is what a turbo motor looks like on a histogram plot. In this case the field is showing where I need to add or pull fuel, but in your case I would have knock in the field. When chasing a motor with knock issues, I would filter out all data where knock was not an issue. The lines show where the motor travels thru the map.
http://www.nbs-stl.com/tuning/Turbo%20D ... %20Adj.png
Andy
http://www.nbs-stl.com/tuning/Turbo%20D ... %20Adj.png
Andy