Nissan VK56 Support
Posted: Tue Dec 12, 2017 9:25 am
Hey all
New to the MS game as I usually play with old school platforms.
I am building a VK56 twin turbo setup. Block is stripped down getting the go-fast parts.
I have been reading and researching the support for MS and the VK56. There were a few threads about the QR25 supporting the trigger wheel and such. But it seems as most have tried that has failed?
Then there was a release note by James saying that its been added but untested. I haven't seen any updates in terms of feedback of it working or not.
Otherwise, if it doesn't officially support it, I will do a basic 36-1 trigger wheel and modify the cam for a single tooth (instead of the current multi). This way I will get the full sequential setup.
Any thoughts or comments for a MS3 newbie?
Thanks in advanced!!!
New to the MS game as I usually play with old school platforms.
I am building a VK56 twin turbo setup. Block is stripped down getting the go-fast parts.
I have been reading and researching the support for MS and the VK56. There were a few threads about the QR25 supporting the trigger wheel and such. But it seems as most have tried that has failed?
Then there was a release note by James saying that its been added but untested. I haven't seen any updates in terms of feedback of it working or not.
Otherwise, if it doesn't officially support it, I will do a basic 36-1 trigger wheel and modify the cam for a single tooth (instead of the current multi). This way I will get the full sequential setup.
Any thoughts or comments for a MS3 newbie?
Thanks in advanced!!!