Megasquirt Support Forum (MSEXTRA)

taylorhoff wrote: Our crank wheel is modified with one tooth removed, making it a 12-1 wheel, which changes the definition of what tooth #1 would be. But in any case, our tooth #1 angle is approximately 0 degrees.

Yes, we still use the cam sensor as well, with two teeth shaved off of the original 3-tooth wheel.

Eheh ok, we have removed the teeth from the crank yesterday, This morning i'm gonnasmake a new gasket and we will try this setting. Hope this will get better results.


Last time we have checked with the timing light and ... from 15° to ... 25° nothing happened and suddently when it goes to 40° advance it worked .... so there is a big step in the advance and we cant go exactly to what is written on the spark map.

At the lastest new, because all the schools here in quebec are in strike, we might have to cancel our trip to detroit. If so, we might put fire to the ms3 and buy something else

http://youtu.be/5nIhcLrKoP0

Look at the video carefully ... it gives retard instead of advance when we rev the engine.

Even if i put the table from 30° to 15° it stills do the same.

hello guys,

i am from yturacing team/turkey i need your help i search base map for 08cbr600rr but i cant found if it is not problem for you can you share me? i wait your advice via pm i am sorry for distrubing you thank you good luck