Page 1 of 1

Half and full indication

Posted: Tue May 29, 2012 9:27 am
by chellquist
Tunerstudio shows fullsync about every third start and I wonder why.
Perhaps there is like a problem with just the TS indication. TS never shows half-sync just only not goes green on the full-sync gauge.
I've runing on 1.06 and are now trying with 1.1 pre20 but with the same behavior. I've 2 cars with this problem.

Setup is 4cyl, vr36-1, hall-gt1, ls2-cop

Re: Half and full indication

Posted: Tue May 29, 2012 9:29 am
by chellquist
composite log for half vs full

Re: Half and full indication

Posted: Wed May 30, 2012 2:33 pm
by jsmcortina
chellquist wrote:TS never shows half-sync just only not goes green on the full-sync gauge.
Not showing green full sync means that it is only half-synced.

With your wheel mode it means that it hasn't yet received the cam signal and will be running wasted-COP ignition.

I'm not able to replicate the symptoms you report on the bench.

If I unplug the cam wire on the stim and increase rpms from zero, it shows as half-sync. When I plug the cam wire in it immediately changes to full sync.

Your comp logs appear to show a valid cam signal.

EDIT: You'll be able to tell if you are in wasted-COP by hooking up a strobe to one of your ignition leads. The rpm will show double.

James