Question about MS3 Firmware license

General support questions and announcements for MS3. See also www.ms3efi.com for MS3 information

Moderators: muythaibxr, jsmcortina

Question about MS3 Firmware license

Postby rusty105 » Tue Jul 31, 2012 6:48 pm

A quick question about the MS3 Firmware license. It says it must be used on a B&G MS3 Board Identified as "MS3 v0.1 (C) 2009" Can the MS3 board be used like a Microsquirt card and used on a custom main board, yet still be acceptable with regards to the license?
Image
rusty105
MS/Extra Newbie
 
Posts: 20
Joined: Wed Jul 07, 2004 11:26 am

Re: Question about MS3 Firmware license

Postby racingmini_mtl » Tue Jul 31, 2012 8:50 pm

As far as I know this is not an acceptable use. At least it wasn't when I asked.

Jean
jbperf.com Main site . . . . . . . . . . . . . . . . . . . . . . jbperf.com Forum
Image
racingmini_mtl
Super MS/Extra'er
 
Posts: 6293
Joined: Sun May 02, 2004 6:51 am
Location: Quebec, Canada

Question about MS3 Firmware license

Postby Acki » Wed Aug 01, 2012 2:21 am

Hmm. A small layout for the MS3 is a must have. The C64 look is not very nice and helpful when it looks brand new like from the junkyard.
Acki
Banned
 
Posts: 200
Joined: Sat Jul 14, 2012 11:29 pm
Location: Germany


Return to MS3 General Support

Who is online

Users browsing this forum: No registered users and 2 guests