Page 1 of 1

Question about MS3 Firmware license

Posted: Tue Jul 31, 2012 6:48 pm
by rusty105
A quick question about the MS3 Firmware license. It says it must be used on a B&G MS3 Board Identified as "MS3 v0.1 (C) 2009" Can the MS3 board be used like a Microsquirt card and used on a custom main board, yet still be acceptable with regards to the license?

Re: Question about MS3 Firmware license

Posted: Tue Jul 31, 2012 8:50 pm
by racingmini_mtl
As far as I know this is not an acceptable use. At least it wasn't when I asked.

Jean

Question about MS3 Firmware license

Posted: Wed Aug 01, 2012 2:21 am
by Acki
Hmm. A small layout for the MS3 is a must have. The C64 look is not very nice and helpful when it looks brand new like from the junkyard.