Drunken_M wrote:Can you help me with setting the right settings in the .msq?....
You really do need to take some more time and really read through it. Just sending the .msq over will not solve all your issues. Just because you have an .msq from another motor like yours... If we take lets say 5 IDENTICAL VW motors, but the MegaSquirts are wired up 5 different ways, it is very likely none of the .msq's will work on the other motors. You need to triple check your outputs and inputs and make sure they are going to the right spots and your .msq is setup accordingly.
Your pictures were not easy for me to tell on proper placement of all your jumpers, but I do see some questionable things. Go over your soldering closely and make sure you have all the parts well soldered. I see a few components with gaps an spaces in the vias. I am not saying this to be mean, but with what I see on the soldering inside and outside the ECU, I think you really need to take some time to clean it up. I would not be surprised, if that is where your issue lies.
Take a super good look at your ECU plug too. I see stray wire strands, any of those shorting to another pin, could cause some very hard problems to trace down. At the very least, all your sensor and power wires should be individually heatshrunk over the ECU connector pins.