MS3 BURNT!!!

General support questions and announcements for MS3. See also MS3 manuals.

Moderators: jsmcortina, muythaibxr

Post Reply
Jakub_lipinski
MS/Extra Newbie
Posts: 4
Joined: Sat Apr 12, 2014 1:27 am

MS3 BURNT!!!

Post by Jakub_lipinski »

Hello
I have one processor MS3 burned, and the other I bought occasionally but it is not working. Is there someone who can fix it?
mr_minnis
Experienced MS/Extra'er
Posts: 162
Joined: Thu Mar 28, 2013 12:05 pm
Location: Near Wichita Kansas

Re: MS3 BURNT!!!

Post by mr_minnis »

I am not sure where you are located. If you are in the states I would contact DIYautotune. If you are in Europe I'd contact James.
88 Stang LX Vert. 3.73s and MS3x, D585 Coils AEM EPM
Jakub_lipinski
MS/Extra Newbie
Posts: 4
Joined: Sat Apr 12, 2014 1:27 am

Re: MS3 BURNT!!!

Post by Jakub_lipinski »

I am of Polish, a lot of people have burned ms3. It should be somewhere officially MS repair information.
James - it jsmcortina?
Matt Cramer
Super MS/Extra'er
Posts: 17499
Joined: Thu Apr 16, 2009 8:08 pm

Re: MS3 BURNT!!!

Post by Matt Cramer »

Yes, that would be jsmcortina.
Matt Cramer -1966 Dodge Dart slant six running on MS3X
jsmcortina
Site Admin
Posts: 39587
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK
Contact:

Re: MS3 BURNT!!!

Post by jsmcortina »

Jakub_lipinski wrote:I am of Polish, a lot of people have burned ms3. It should be somewhere officially MS repair information.
How are these MS3 cards getting damaged and why ?

James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Jakub_lipinski
MS/Extra Newbie
Posts: 4
Joined: Sat Apr 12, 2014 1:27 am

Re: MS3 BURNT!!!

Post by Jakub_lipinski »

Hello
I wrote you a PM.
One plate got 12v to gnd how do I find a picture and show you how it looks :)
The second I bought used, had to be good.
  He can not upload the firmware.
jsmcortina
Site Admin
Posts: 39587
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK
Contact:

Re: MS3 BURNT!!!

Post by jsmcortina »

Jakub_lipinski wrote:Hello
I wrote you a PM.
One plate got 12v to gnd how do I find a picture and show you how it looks :)
If the PCB is genuinely burned out then it may not be repairable. All damaged MS3 cards I've repaired so far had a broken processor, but the PCB itself was fine.

James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Post Reply