map sensor pins?

[maxo-tt1]

hello people, i got mapdaddy 4 bar sensor. can someone tell me whats that 6 pin? or at least wanna find ground power and signal pins.

http://www.diyautotune.com/catalog/mapd ... p-117.html

[Matt Cramer]

Here you go.

[SDelong]

Here you go.

What if you would like to use the 2nd for baro correction? I assume the 3 pins labeled NC would be(from left to right as pictured) 1- 5v, 2 - Ground, 3 - Map out as well?

[Matt Cramer]

NC means no connection.

[SDelong]

So those 3 pins literally have no purpose in any application? Mainly I am asking if the first 3 pins have any relation to the 2nd baro port and understand that NC means no connection.

[Matt Cramer]

The 3 NC pins serve the purpose of providing mechanical support for the MapDaddy.

[SDelong]

Thanks for the clarification!

[jasaircraft]

Here you go.

Hi Matt, can you post that image or something again please?

[jsmcortina]

Try this:
http://www.farnell.com/datasheets/22915 ... 1485440435

James

[jasaircraft]

Thanks James

[jasaircraft]

Hi im swapping sensors on a mapdaddy 4 bar map sensor, the main sensor has gone bad (signal is permanently highest vacuum) so i swapped connections to use the other one. Why could this sensor have gone bad?

[jsmcortina]

Oil or water contamination most likely.

James