I am considering converting my v6 over to ms3 and adding lsx coils to it but the injectors are low-z and I would rather not have to replace them. Can I use the two drivers on the main board in batch mode with the coils run in sequential cop mode?
I will have the appropriate crank/cam sensors.
thanks
dave
Possible to run COP with batch injection
Moderators: jsmcortina, muythaibxr
-
- MS/Extra Newbie
- Posts: 6
- Joined: Tue Oct 30, 2012 9:14 am
-
- Site Admin
- Posts: 39619
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Possible to run COP with batch injection
Yes you can.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".