I can't start my jeep V8
Moderators: jsmcortina, muythaibxr
-
- Helpful MS/Extra'er
- Posts: 85
- Joined: Thu Jul 26, 2012 3:26 am
- Location: Spain
I can't start my jeep V8
On the gauge cluster I can see that the fuel load says INVALID (???).
Where might be the problem?
I have attached a data log. Also a shot screen with the engine running with its own fuel and ignition system.
-
- Super MS/Extra'er
- Posts: 17507
- Joined: Thu Apr 16, 2009 8:08 pm
Re: I can't start my jeep V8
Looks like you need to:
1. Confirm the timing is correct.
2. Adjust the cranking pulse width.
The invalid fuel load is purely a TunerStudio gauge setting issue. Right click on the dash, select Load / Save, and reload the default dash - it should come up with the fuel load displayed correctly.
1. Confirm the timing is correct.
2. Adjust the cranking pulse width.
The invalid fuel load is purely a TunerStudio gauge setting issue. Right click on the dash, select Load / Save, and reload the default dash - it should come up with the fuel load displayed correctly.
Matt Cramer -1966 Dodge Dart slant six running on MS3X
-
- Helpful MS/Extra'er
- Posts: 85
- Joined: Thu Jul 26, 2012 3:26 am
- Location: Spain
Re: I can't start my jeep V8
I'm very happy . I have already started my engine, no very well, but it runs...
I'm going to install a wideband o2 sensor and then I'll try autotune with TunerStudio.
Thanks.
I'm going to install a wideband o2 sensor and then I'll try autotune with TunerStudio.
Thanks.