Im getting to the point of having power hooked up to test everything.
I tested all coils and they are working fine, but I can't test the injectors.... The "start" button in TS is greyed out so I can't click on it.
1.3.0 FW w/ TS 2.6.04
I attached an .msq if it helps.
injector test start button greyed?
Moderators: jsmcortina, muythaibxr
injector test start button greyed?
Im getting to the point of having power hooked up to test everything.
I tested all coils and they are working fine, but I can't test the injectors.... The "start" button in TS is greyed out so I can't click on it.
1.3.0 FW w/ TS 2.6.04
Here's a screen snip to show I'm not crazy...yet ..LOL
I attached an .msq if it helps.
I tested all coils and they are working fine, but I can't test the injectors.... The "start" button in TS is greyed out so I can't click on it.
1.3.0 FW w/ TS 2.6.04
Here's a screen snip to show I'm not crazy...yet ..LOL
I attached an .msq if it helps.
Re: injector test start button greyed?
in the screen shot the total number of injections is set to 0 does it make a diff if you change that number?
1990 bmw 320i daily driver with m20b25 ms3 sequential fuel, 380cc injectors, d585 coil near plug, home made cam sync, launch control, fan control, vss, homebrew egt logging what's next????
Re: injector test start button greyed?
I did not see that setting... I will test and report back.
Re: injector test start button greyed?
That did the trick....so I may not be "crazy" but unfortunatley the evidence points towards "stupid."