1 tooth crank and cam
Moderators: jsmcortina, muythaibxr
1 tooth crank and cam
Hello. I have 6 cylinder engine, MS3X, VR crank and cam sensors(1 tooth). Can I use sequential spark(COP) and injector. What setting I must set in TunerStudio in ignition options? I'm sorry if this question has already been discussed on the forum, or is in the instructions and for my bad english.
-
- Site Admin
- Posts: 39585
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: 1 tooth crank and cam
Just to confirm, are you saying:
crank wheel has one tooth ?
cam wheel has one tooth ?
James
crank wheel has one tooth ?
cam wheel has one tooth ?
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: 1 tooth crank and cam
Crank wheel has one tooth and cam wheel has one tooth.
-
- Site Admin
- Posts: 39585
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: 1 tooth crank and cam
Unfortunanately, that will not work.
For a six cylinder engine, as a minimum you need three teeth on the crank. I would recommend installing an aftermarket 36-1 trigger wheel.
James
For a six cylinder engine, as a minimum you need three teeth on the crank. I would recommend installing an aftermarket 36-1 trigger wheel.
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: 1 tooth crank and cam
Thank you.
-
- Super MS/Extra'er
- Posts: 17499
- Joined: Thu Apr 16, 2009 8:08 pm
Re: 1 tooth crank and cam
Is it possible there's a third sensor here that reads flywheel teeth? If so, how many teeth are on the flywheel?
Matt Cramer -1966 Dodge Dart slant six running on MS3X