Hi,
Something strange happened few days ago, to make the long story short, MS3-pro was installed on 2JZVVTI two weeks ago. The car was working fine, during the dyno session (few days ago) the car went rich all of a sudden, and started flooding. At idle the wideband reads 10 until it dies. All pistons became flooded of fuel.
We thought that the injectors got damaged, we sent them out for cleaning and repair, installed them back, no change. Then we got new identical set (ID1000), and the same thing. I swapped the ecu with the one of my car, the customer's car is working fine.
I updated the firmware of the ecu, and no luck still flooding. If you came the same issue before, or you think that the injector driver in the ecu is damaged and we can do something please lemme know.
Thanks,
Damaged ECU
Moderators: jsmcortina, muythaibxr
Damaged ECU
Last edited by odd boy on Fri Feb 20, 2015 1:41 am, edited 1 time in total.
Re: Damaged ECU
you might the serial no. of the ecu: 300145416711
-
- Site Admin
- Posts: 39618
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Damaged ECU
It is best to contact your supplier directly for a faster response.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".